joucomatic 881 Serie Puesta En Marcha Y Consejos De Utilización página 13

MOUNTING ON CYLINDERS WITH DOVETAIL GROOVES - TYPES K, KN, PEC,PES,P2B, P2L:
1 st ASSEMBLY
A
B
3
2
C
5
2 nd ASSEMBLY
A
1a
90˚
Proceed with Installation, adjustment and tightening as described in phases B and C (steps 2 to 6) above.
90˚
1
4
0,14 N.m
6
90˚
2a
A PREPARATION
1 - Turn the knurled nut manually by
90° so that it is retracted inside.
INSTALLATION / ADJUSTMENT
B
2 - Engage the detector into the
groove.
3 - Press the detector down into the
groove.
4 - Position the detector at the measur-
ing point.
Note:
To control end of stroke positions
observe recommendations given op-
posite.
C TIGHTENING
5 - Hold the detector in place and
tighten the screw. This causes the
knurled nut to rotate.
- Make sure the detector is correctly
placed in the groove (perpendicular
to the groove's axis).
6 - Block the detector on the cylinder.
Maximum screw tightening torque:
0.14 N.m
A PREPARATION
1a- Loosen the screw. This causes the
knurled nut to rotate by 90° and be
retracted inside.
2a- Continue loosening the screw
until the knurled nut is in the bot-
tom position and the bottom end
of the screw is fl ush with the
bottom of the nut (see drawing
opposite).
11