Connect Power Cord - GE PSB42 Manual Del Propietario E Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 6 ANTI-TIP PROCEDURE
(Cont.)
• The screws must penetrate at least one inch into the
vertical wall studs.
screws in place of wood screws.
IMPORTANT: When the refrigerator is installed under
a soffit or if there is not enough height for this method
of security, brackets cannot be used. Proceed to step
7 to level the refrigerator and then to step 8 to secure
refrigerator to cabinets.
secured to prevent tipping.

Connect power cord:

• Before pushing the refrigerator into the opening,
plug the power cord into the receptacle. The water
filter guard will need to be removed for access
(some models). Remove the 3 screws holding it in
holding the water filter bracket and move aside.
Open the grille panel and reach into the opening at
the back to grasp the power cord. Pull the power
cord into the opening as you push the refrigerator
back. Secure the bracket and guard with the original
screws.
• Gently push refrigerator into the opening with hands
against front corners.
22
Installation Instructions
The refrigerator must be
STEP 7 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is
supported by leveling legs, the rear is supported by
adjustable wheels. Both are accessible from the front
of the refrigerator.
hex nut located above the front wheels. Turn
clockwise to raise or
counterclockwise to lower
the refrigerator.
• For front leveling, use a
• Adjust height of
refrigerator to match
installation cutout
cm). The refrigerator should be level and plumb with
cabinetry.
NOTICE: The rear leveling wheels and front leveling
elevate the refrigerator on a sheet of plywood or
runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the refrigerator more than 1" (2.54
cm), you will damage the front leveling legs and
the rear leveling wheels. Make adjustments in
small increments.
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
holes through the metal top case trim.
49-1000364 Rev. 1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Psb48

Tabla de contenido