Test Run
Test the machine to set it to count your currency. Prepare at least five bills to test the machine. Place the bills on the hopper
and run the machine. If the machine counts the bills and there are no errors, it is ready to accept your currency.
If: 1. The bills are deformed
2. The machine is considerably slow
3. Error message is lit frequently
The hopper tension is too tight. To loosen this tension, please turn the Bill Thickness Adjuster one notch to the right (+).
Place the bills back into the hopper to test the machine again. If errors occur, adjust as necessary.
If: 1. The bills are flying out
2. The display shows a miscount
3. Error message is lit frequently
The hopper tension is too loose. To tighten this tension, please turn the Bill Thickness Adjuster one notch to the left (-).
Place the bills back into the hopper to test the machine again. If errors occur, adjust as necessary. When the machine is
running without any errors, it is ready to accept your currency. Insert bills into the hopper to begin counting.
Add Mode:
Press ADD key and "ADD" will show in display. The machine will accumulate all counting numbers. Pressing ADD key again
will turn off this feature.
Batch Mode:
Press BATCH key and "100" will flash on display. Press the number you wish to batch. Batch number can be set between
1-999. Press BATCH key again to turn this feature off.
Value Counting:
Single denomination counting-
Select denomination to be counted from the Numeric/Denomination keypad
Place bills in hopper. Total number of bills and denomination value will show on display screen after bills are counted.
Multi-Denomination Value Counting-
Press ADD key.
Select denomination to be counted from the Numeric/Denomination keypad
Place bills in hopper.
Select next denomination and repeat process above.
After all denominations are have been counted hit the DISPLAY key and the number of bills and value for each denomination
along with a grand total will show on the display screen.
9
RBC-4500