Install The Whirlpool Trim Kit; Test Run The Whirlpool - Kohler K-1360 Guia De Instalacion

8. Install the Whirlpool Trim Kit

Install the whirlpool trim kit (if not factory installed) according to the instructions packed with the
trim kit. Pay particular attention to the jet installation steps below - they are very important and are
included here to help you obtain smooth, trouble-free jet operation.
NOTE: The jet O-ring must be correctly positioned, must be lubricated, and must be in good condition to
permit easy rotation and proper operation of the jet.
Install the O-ring onto the first shoulder of the jet. Lubricate the O-ring with silicone lubricant to
prevent noisy operation of the jet.
Carefully insert the jet into the housing, and lightly push and rotate the jet until it snaps into
position. Do not force the jet.
NOTE: When installed correctly, the jet should turn smoothly both clockwise and counterclockwise.

9. Test Run the Whirlpool

Check all electrical connections, then make sure all union connections to the pumps and heater are
securely hand tightened.
Verify both sets of pump banding straps have been cut and the pump controls are resting directly
on the subfloor. Ensure the rubber isolation feet are in place.
Turn electrical power to the whirlpool on.
Fill the whirlpool to a level above the Riverjet water level sensors located on either side of the
Riverjets.
Operate the whirlpool for 5 minutes (refer to the "Operating Sequence" section).
Check for leaks coming from the piping connections on the back side of the whirlpool unit.
Turn on the each of the whirlpool features and verify proper function. Check for any water leakage
on the whirlpool's back side.
If equipped, turn on the chromatherapy cycle and allow it to sequence through all eight colors;
white, violet, indigo blue, aqua blue, green, yellow, orange and red. It takes approximately 1 minute
to cycle through all eight colors.
Verify functions using the remote control. Refer to the "Remote Control Operation" section.
NOTE: For additional information on whirlpool operation, see the "Confirm Proper Operation" section of
this guide.
Kohler Co.
Housing
Inspect and
lubricate the
O-Ring.
Insert the jet into the housing,
and lightly push and rotate
until it snaps in position.
Slide the O-Ring
onto the first
shoulder of the jet.
11 1022211-2-C