Comfort Glow ERH4465 Manual Del Operador página 5

PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from box. (Please SAVE the Box for off season storage.)
2. Make sure the heater is switched OFF before plugging the heater into the outlet. Connect to properly grounded
outlets only. Note: The power cord has a polarized plug (with one blade wider than the other) that will only fit
in a polarized outlet one way. If it does not insert easily try reversing the plug. If it still does not fit contact your
electrician to replace your outlet. DO NOT defeat the safety purpose of the polarized plug.
3. Place heater only on a firm level surface, free from obstructions and at least 3 ft. away from any wall or other
objects such as curtains, plants, etc.
4. Avoid overloading your circuit by not using other high wattage appliances in the same outlet.
HOW TO USE YOUR HEATER
1. Completely uncoil the cord and plug heater directly into a 110~120 Volt grounded AC wall outlet. Be sure the
plug fits tightly. A loose fit will cause overheating and damage the plug. Plug and cord may feel warm during
normal usage.
2. Choose your Power Setting: High, Low, Fan or OFF. Use the High setting to warm the room quickly. After your
comfort level has been achieved you may want to switch to the Low setting to conserve electricity.
3. Thermostat: Turn to highest setting until room is comfortable. Then slowly rotate the knob counter clockwise
(left) until the heater cycles OFF. At this SET POINT the heater will cycle On and Off to maintain this comfort
level.
Note: During the initial use, you may experience a slight odor or smoking. This is the result of the
heating element fabrication protective coating burning off". This is normal and will go away after
60 minutes of use.
PLEASE READ BEFORE OPERATING
~ 5