Switch Off; Adjusting The Volume; Listening To The Radio - Lenco MC-013 Manual Del Usuario

3� Open the CD compartment (push and release the lid on the front right), and remove the cardboard
shipping protector� Close the CD lid�
4� Plug the mains power plug into the mains power wall socket and switch on� Your Micro will now be in
'Standby' mode�
SWITCH ON
Press and release the 'Power' button on the front of the Micro to switch on�
FM Radio, CD and Aux in modes are available�
Please check the display, which will confirm the mode.

SWITCH OFF

Press and hold the 'Power' button to go to standby mode�
To completely power off the Micro, switch off the mains power at the wall socket.

ADJUSTING THE VOLUME

Turn the rotary volume control to adjust the volume. Turn clockwise to increase the volume and anti-
clockwise to decrease the volume�

LISTENING TO THE RADIO

Please make sure that the wire antenna on the back of the Micro is fully extended and adjusted before
you attempt to tune to an FM radio station�
Check that your Micro is in FM radio mode. If you are not already in FM mode, briefly press and release
the 'Mode' button until you are in FM mode (check the display)�
TUNING TO A FM STATION
Press and hold the Tune
available station and then stop on that station� Press and release the button to scan up the frequency
band in 0�05MHz steps�
Press and hold the Tune
available station and then stop on that station� Press and release the button to scan down the frequency
band in 0�05MHz steps�
Note: If reception is poor check that the wire antenna is fully extended or try moving the Micro to another
location�
STORING A FM STATION PRESET
Your Micro can store up to 30 FM radio stations in its preset memories for instant access to your favourite
stations�
Tune the Micro to the FM radio station that you wish to preset.
1� Press the 'Prog' button and 'P XX' starts flashing on the display (where XX is the preset number).
2� Use P+ P- buttons to move to the preset number that you would like to store the radio station to (1-30).
3� Press and release the 'Prog' button, 'P XX' will stop flashing confirming that the preset has been
stored�
button to scan up the frequency band, your Micro will search for the next
button to scan down the frequency band, your Micro will search for the next
7