Manufacturer'S Declaration - PLYMOVENT SFE-25 Instrucciones Para El Uso

CE DECLARATIONS
SFE 25/50/75:

MANUFACTURER'S DECLARATION

(Directive 98/37/EEC, Annex II, sub B)
Plymovent, Alkmaar, the Netherlands herewith
declares that the following machinery components are
intended to be assembled with other machinery
components to constitute machinery, which shall not
be put into service until the entire installation has been
declared in conformity with the provisions of the EC
Council Directive and/or the local Directives on
Machinery and the instructions of the manual of the
machinery components: SFE 25/50/75.
Applied harmonized standards, in particular:
- EN 292-1
- EN 292-2
- EN 294
- EN 349
- EN 60335-1
- EN 60335-2
- EN 55014
- EN 61000
Remark:
Taking the machine in question into operation is only
allowed after determination that the entire installation,
of which the machinery component(s) in question
form(s) part, is in compliance with the Directive 98/37/
EEC and with the local Directives. These Directives
specially guarantee the user's safety by means of,
among other things, electrical emergency stops, fuses,
earth wires and touch prevention for running and
charged components. The installation manufacturer is
responsible for taking the entire system into operation.
Alkmaar, 1st March 2005
Ing. C.J.M. Knijn
0508080010/SFE-HFE/010111/G
HFE 25/50:
EC-DECLARATION OF CONFORMITY FOR
MACHINERY
(Directive 98/37/EEC, Annex II, sub A)
Plymovent, Alkmaar, the Netherlands
herewith declares that the following products: HFE 25/
50
are in compliance with the Directives:
• 93/68/EEC
• EMC 89/336/EEC
• 73/23/EEC
the following harmonized standards have been applied:
• EN 60335-1
• EN 60335-2
• EN 292-1
• EN 292-2
• EN 294
• EN 55014
• EN 61000
Alkmaar, 1st March 2005
Ing. C.J.M. Knijn
EN - 17