Rinse Aid - KENMORE ELITE 722.1435 Serie Manual De Uso Y Cuidado

IMPORTANT: The dishwasher is designed to use rinse aid.
The use of rinse aids greatly improves drying by allowing
water to drain from the dishes after the final rinse. Rinse
aids also keep water from forming droplets that can dry as
spots or streaks.
Adding Rinse Aid
How often the dispenser needs to be refilled depends on
how often dishes are washed and the rinse aid setting used.
The Rinse Aid ( ) icon flashes when more rinse aid is
needed, unless the rinse aid dispenser setting is set to L0.
1. To add rinse aid, open the rinse aid lid by lifting up the
flap.
2. Add a liquid rinse aid to the maximum fill level. Do not
overfill the rinse aid dispenser.
3. Clean up any spilled rinse aid. Spilled rinse aid can
create excessive suds.
4. Close the lid to lock the dispenser. Rinse aid is dispensed
automatically during the final rinse cycle.
NOTE: Only use liquid rinse aid in the dishwasher.
12

Rinse Aid

Rinse Aid Dispenser Adjustment
The dispenser has five adjustment levels. The dishwasher is
programmed at the factory for a rinse aid dispenser level of
2. This can be checked and altered by using the buttons on
the control panel.
1. Ensure the appliance is off.
2. Press Mixed Load and Power simultaneously to check the
current setting.
3. Press Delay Hours to change the rinse aid dispenser
setting. Each press of the button changes the setting one
step from L0 to L4.
4. Once the desired rinse aid dispenser setting is selected,
press Start to save.
NOTE:
• Adjust the setting higher if you have hard water and
notice calcium buildup on your dishes.
• Setting the rinse aid control too low will contribute
to spotting and streaking on dishes and poor drying
performance.
• Setting the control too high can cause foaming, which will
cause poor wash performance.