Manual Operation - Niko 05-350 Manual Del Usuario

05-350 / 05-338
3.4. selective erase, resetting one transmitter
prog.
1. Apply 1 long (>1.6s) press on button, a bleep signal sounds.
2. Use the button to switch ON the required channel on the receiver.
3. Press the push button to be erased on the hand held transmitter or wall-mount transmitter.
This is acknowledged by a short bleep signal.
prog.
4. Apply a brief (<1.6s) press to the button to end the programming.

3.5. manual operation

The 'select' push button at the front of the device can be used to switch the output on or off.
With the 2-channel receiver the output can be switched for an indefinite period of time in
shutter mode. Times are not taken into account.
Apply a long (>1.6s) press to the 'select' button = output ON or OFF.
44 EN