Troubleshooting - GreenWorks GPW 2001 Manual De Instrucciones

TROUBLESHOOTING

PROBLEM
Motor will not start.
Unit does not reach
high pressure.
Output pressure varies
high and low.
POSSIBLE CAUSE
On/Off switch is in the
"OFF" (O) position.
Power cord is not plugged in.
Electrical outlet does not sup-
ply adequate power.
Tripped pressure washer
circuit breaker
Power switch is ON however
gun trigger is not squeezed
ON.
Diameter of garden hose is
too small.
Water supply is restricted.
Not enough water supply.
Power nozzle is in low-
pressure position.
Not enough inlet water supply.
Pump is sucking air.
24
SOLUTION
Turn switch to the "ON"
( | ) position.
Plug in power cord.
Try a different outlet.
Allow to cool, and restart unit.
With power switch ON push in
on the gun trigger which will
engage the AUTO ON switch
Replace with a 1" (25 mm) or 5/8"
(16 mm) garden hose.
Check garden hose for kinks,
leaks and blockage.
Open water source fully.
water.
Turn power nozzle to high-
pressure position.
Turn water on fully. Check garden
hose for kinks, leaks or blockage
airtight. Turn "OFF" machine, and
purge pump by squeezing trigger
emerges through the nozzle.
water.