Installing The Receiver Unit And Switch Cup Housing; Maintenance; Blade Cleaning - Fanimation HF6050 Serie Manual Del Propietário

Installing the Receiver Unit and Switch Cup Housing

NOTE: This step is applicable for model without lower
Light Kits.
For Forged Leaf or Presidio Tryne
section and go to page 14 or 16.
1. Install receiver unit in the switch cup cover by align the
two green dots. Carefully connect the main connector &
antenna wire connector and push all wires back into switch
housing of fan. (Figures 1a and 1b).
▲WARNING
Check to see that all connections are tight. To avoid
possible electrical shock, make sure that the wires are
completely inside the switch housing and not pinched
between the switch cup base and the housing.
2. Install the assembled switch cup cover (align the two
orange dots) using two flat head screws provided.
(Figure 2).
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the fi nish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to fi nish.
Periodic light dusting of the blades is recommended.
A feather duster will work best.
fan models, skip this
™
Antenna Wire
Connector
Figure 1a

Maintenance

Blade Cleaning

IMPORTANT!
Align Green
Dots
CAUTION
Do not use water when cleaning your ceiling fan. It could
damage the motor or the finish and create the possibility
of electrical shock.
Avoid using water, cleansers, or harsh rags, which can
warp and ruin the blade and the fi nish.
11
IMPORTANT!
Align Orange
Dots
Figure 1b
Figure 2