Installing The Canopy Housing; Installing And Mounting The Fan Blades - Fanimation Andover FP5220 Serie Manual Del Propietário

▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Screw in two threaded rods into the Hanger Bracket
(Figure 1a).
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled knobs
supplied with your fan (Figure 1b).
Assembling and Mounting the Fan Blades
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
1. Remove and discard the (steel) motor "stops" by
removing the five screws. (Figure 1)
Blade & Blade Holder Assembly:
2. Lay blade holder with the threaded posts facing up.
3. Assemble the blade to the blade holder with the washer
screws with fiber washers.
4. With a Phillips screwdriver, tighten washer-head screws
with fiber washers. Do not over-tighten. (Figure 2)
5. Attach assembled blades and blade holders to the motor
hub using the provided screws with lock washers.
(Figure 3)
6. Make sure the screws securing the blade holders to the
motor hub are tight and properly seated.

Installing the Canopy Housing

Figure 1a
Fan Blade
Screw
(2 per blade
holder)
8
Figure 1b
Figure 1
Figure 2
Blade Holder
Figure 3