Technical Data; Delivery Scope - Bosch GTA 2500 W Manual Original

OBJ_BUCH-854-006.book Page 17 Thursday, November 10, 2016 4:49 PM
19 Fastening kit
20 Limit bolt
21 Locking plate
22 Wing nut
23 Button for releasing lever 24
24 Lever for locking the attachment set
25 Stop
26 Movable nut
27 Nut for adjustment of lock 9
28 Nut for adjustment of limit bolt 20
29 Adjustment screw for limit bolt 20
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.

Technical Data

Saw stand
Article number
Length of saw stand without
table extension mm
Length of saw stand with table
extension mm
Height of saw stand mm
Max. carrying capacity
(power tool + workpiece)
– Attachment set kg
Max. carrying capacity
(power tool + workpiece)
with table extension
– Attachment set kg
– Per table extension kg
Weight according to
EPTA-Procedure 01:2014 kg
Assembly

Delivery Scope

Please also observe the representation of
the delivery scope at the beginning of the op-
erating instructions.
Before assembling the saw stand, check if all
parts listed below are provided:
No. Designation
1 Attachment set
2 Saw stand with support 8
13 Upper frame
with lock 3
17 Bottom frame
14 Foot lever
15 Wheel "L"
16 Wheel "R"
18 Supporting frame
Bosch Power Tools
No. Designation
19 Fastening kit
consisting of:
– Hexagon bolt
M10 x 100
M10 x 55
M10 x 50 (self-locking)
M8 x 45
M6 x 45
– Phillips screw
M8 x 50
– Washer
M10 x 29 mm
M10
M8
M6
– Lock nut
M10
GTA 2500 W
M8
3 601 M12 102
M6
1044 Additionally required tools (not in delivery scope):
– Phillips screwdriver
– Open-end spanner (10 mm, 8 mm, 6 mm)
2510
– Adjustable spanner
947
Assembling the Mobile Stand Base
– Carefully remove all parts included in the delivery from
180
their packaging.
– Remove all packaging material. (e. g. cable ties, etc.)
– For assembly, follow figures A–E. Also observe the follow-
ing notes.
130
For Fig. B:
25
The wheels are marked for easier assembly ("R" for right
wheel, "L" for left wheel).
32.2
Note: Do not over-tighten the nuts. Parts bolted together
must move freely.
For Fig. D:
Observe the correct assembly direction of supporting frame
18, which is indicated by the marks "R" and "L" matching the
wheels.
Note: Do not over-tighten the nuts. Parts bolted together
must move freely.
For Fig. E1:
Quantity
In this assembly step, the saw stand 2 is bolted together with
2
the supporting frame rest 18 and the upper frame rest 13.
1 – Set both rest so that the lateral recesses in the rests face
towards the handle.
– While bolting the saw stand together, take care that the
1
support 8 is always in the fixture of the bottom frame 17.
1
Note: Only hand-tighten the nuts at first. After all eight bolts
1
are correctly positioned, they can be firmly tightened.
1
For Fig. E2:
1
Note: Do not over-tighten the nuts. Parts bolted together
1
must move freely.
English | 17
Quantity
4
1
2
4
8
4
2
10
4
8
5
4
8
1 609 92A 2P6 | (10.11.16)