Starting failure
Check
Starter pawls
Fuel tank
Sparking (no spark)
Spark plug
Engine starts but does not stay running
Check
Fuel tank
Carburettor
Air filter
Fuel filter
Transportation and storage
•
Always store the chainsaw and fuel so that there is
no risk of leakages or fumes coming into contact with
sparks or naked flames from electrical equipment,
electric motors, relays/switches, boilers and the like.
•
Always store fuel in an approved container designed
for that purpose.
•
For longer periods of storage or for transport of the
chainsaw, the fuel and chain oil tanks should be
emptied. Ask where you can dispose waste fuel and
chain oil at your local petrol station.
32
Troubleshooting
Possible cause
Binding pawls
Incorrect fuel type.
Spark plug contaminated or wet
Spark plug gap incorrect.
Spark plug loose.
Possible cause
Incorrect fuel type.
Engine will not idle properly.
Clogged air filter.
Clogged fuel filter.
Transportation and storage
Action
Adjust or replace the pawls.
Clean around the pawls.
Contact an authorised service work-
shop.
Drain it and use correct fuel.
Make sure that the spark plug is dry
and clean.
Clean the spark plug. Check that the
electrode gap is correct. Make sure
that the spark plug is fitted with a
suppressor.
Refer to rechnical data for correct
electrode gap.
Retighten the spark plug.
Possible action
Drain it and use correct fuel.
Contact your service agent.
Clean the air filter.
Replace the fuel filter.
•
The guide bar cover must always be fitted to the
cutting attachment when the product is being
transported or in storage, in order to prevent
accident contact with the sharp saw chain. Even a
non-moving saw chain can cause serious cuts to
yourself or persons you bump into with an exposed
saw chain.
•
Remove the spark plug cap from the spark plug and
activate the chain brake before storage or transport.
•
Secure the product during transport.
308 - 004 - 27.09.2017