AEG SKB588E1AS Manual De Instrucciones página 13

Problem
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
The temperature in the appli‐
ance is too low/too high.
Possible cause
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
ENGLISH
Solution
Set a higher temperature.
Refer to "Control Panel"
chapter.
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
13