Selecting The Wash Cycle; Thermo-Stop; Stopping The Wash Cycle And End Of Wash Cycle; Drainage Of The Machine - edenox T-OEM-350 Instrucciones De Instalación, Uso Y Mantenimiento

EN

Place the cutlery in the cutlery baskets with the handles downwards. The different pieces of
cutlery can be mixed.

Place the cutlery baskets in the lower baskets.

5.1.5 Selecting the wash cycle

Before starting the wash cycle, place the corresponding basket containing the dishes in the machine.
To start the wash process first close the door and then select the wash cycle you wish to run for 1.5
s. The wash cycle will start automatically. Each wash cycle runs for a set time that is selected
according to how dirty the plates are (90 s/120 s/180 s).
The door must be closed for the machine to start the wash cycle. For safety reasons,
if the door is open, the wash cycle will not start.

5.1.6 Thermo-stop

The thermo-stop guarantees a constant rinse at a temperature of 85 ⁰C. This means that the
machine continues washing until the boiler reaches the ideal temperature. Then the rinse cycle
starts.

5.1.7 Stopping the wash cycle and end of wash cycle

The wash cycle can be stopped in the following ways:

By switching off the machine → the cycle stops completely.

By opening the door → when the door is closed, the cycle continues.
At the end of the wash cycle, remove the basket and leave the dishes to dry naturally. Remove the
dishes from the basket with clean hands, taking care not to burn yourself as the dishes are extremely
hot.
5.1.8 Cold rinse (only T-OEM-400 MOD. and versions)
The machine you have purchased has a cold rinse system so that once the tableware has been
washed, it can be cooled quickly ready for subsequent use. To activate the cold rinse system, turn
the control button to cold rinse (D) and hold down for the required time.

5.1.9 Drainage of the machine

The dishwashers have two types of drainage; gravity drainage or using a drainage pump.
5.1.9.1 Drainage by gravity
To drain the machine in this way, just remove the overflow from the machine and it will drain
naturally. For reasons of safety, this method of drainage should only be used with the machine
switched off.
5.1.9.2 Drainage using the drainage pump (optional)
The drainage using the drainage pump option is only available on request. The drainage pipe must
always be fitted on a siphon to prevent the return of odours.To drain the machine using this method,
proceed as follows:

Remove the overflow valve.

Leave the door open.

Press the drain button (B) for 3 seconds and the drainage cycle will start automatically.

At the end of the cycle (approx. 160 s), replace the overflow valve. The machine may be
switched off.

5.1.10 Switching off the machine

The dishwasher is switched off by pressing the ON-OFF button for 1.5 s.
The machine should not be switched off during the wash process as this will stop the tableware
inside the machine from being cleaned properly.

5.1.11 Cleaning the machine at the end of the day

At the end of the day, the filters, wash distributors, rinse branches and other accessories must be
cleaned. This is necessary to prolong the service life of the machine. To ensure the efficient washing
of the dishes, the dishwasher must be perfectly clean and disinfected.

5.2 Useful tips

Read the useful tips listed below carefully to allow you to get the most out of your dishwasher.

5.2.1 Maintenance

40
To drain the machine with the drainage pump, the hose must be at a
height (max. 680 mm).