Boiling Out With The Hand Spray; Polymerising; Cleaning And Maintenance; Checking The Water Level - Dreve LABORMAT SD Instrucción

Labormat SD

6.4 Boiling out with the hand spray

The Labormat SD avails of double lids.
The item to be cleaned (e. g. articula-
tor) can be placed on the perforated
plate covering for brief boiling out using
the hand spray (30). The spray water
is redirected into the water tank via
discharge holes in the inside lid. When
using the hand spray (30), the change-
over lever (52) in the control panel must
be rotated right to set it at the „hand
spray" position. Remove the hand spray
(30) from the holder, set the timer (18)
to the designated cleaning time or press
the hold button (15) while pressing the
pressure switch on the hand spray.
Return to normal spray mode by rotat-

6.5 Polymerising

Labormat devices are also suitable for
polymerising hot-polymerising resines
using the metal flask technology.
Do this by opening the lid of the device (3),
removing the flask baskets and support
plates (55) and submerging the flasks
directly in the preheated water tank.
Caution: risk of burning – only touch
using the designated handles.
It must be ensured that flasks are not
placed on the heating coil and measur-
48
ing the change-over lever (52) to the
left to set it at the „spray" position.
Important: The timers on the
Labormat device should not be
turned anticlockwise mechanically.
This over-stresses the internal
parts and can expose the clocks
to fast wear.
ing sensors in the front section of the
water tank. This can cause functional
defects or damage.
Various temperature levels can be real-
ised via the thermostat controller (24)
to ensure homogeneous resin polymeri-
sation.
During the polymerisation process, the
Labormat can also be used as a boil-out
unit; replace the support plates and flask
baskets in the device and proceed as
outlined in the section on „Boiling out".

7. Cleaning and maintenance

7.1 Checking the water level

Labormat devices are hot water devices imperative that water is added (please
which release steam during the spray refer to the section on „Filling with
process and when the lid is open. This water").
lowers the water level and necessitates If the water level falls to the level of
checking the water level on a daily the heating coil (29), a safety switch
basis. When there is a gap of approx. isolates the entire device from the mains
10 cm between the water surface and supply to protect against overheating.
the maximum water level mark, it is
7.2 Restoring operational readiness after triggering the
safety switch
Important: Always pull the main direction and press the green locking
plug before opening the device. button underneath until it audibly clicks
into place.
The overheating protection safety Immediately replace the protective cap
switch (21) is located on the control on the locking button on account of
panel (9) and is secured with a pro- the risk of electrical components being
tective cap. damaged by water.
If reactivation is necessary, release
the protective cap in an anticlockwise
49