Cleaning; Resetting Factory Settings; Decommissioning; Disposal - Alpha IP MIOB 21001-XX Manual Del Usuario

Display
1 long lighting, red
6x long flashing, red
1 lighting in orange
and 1 lighting in
green

9 Cleaning

Only use a dry and solvent-free, soft cloth for cleaning.

10 Resetting factory settings

All settings will be lost when the factory settings are restored.
1. Keep the System key (A) pressed for 4 seconds, until it flashes rapidly in orange.
2. Release the System key.
3. Press the System key again for 4 seconds until it lights up in green.
4. Release the System key again.
9 The factory settings are reset.
9 The device restarts.

11 Decommissioning

WARNING
Danger to life due to the electrical voltage at the Multi-IO Box!
• Only an authorised electrician may open the device.
• Always disconnect from the mains network and secure against unintended activation before open-
ing.
• Disconnect external voltages and secure against activation.
1. Loosen all connected cables.
2. Uninstall the device and dispose of properly.

12 Disposal

Do not dispose of the device with domestic waste! Electronic devices/products must be disposed
of according to the Directive for Waste Electrical and Electronic Equipment at the local collection
points for waste electronic equipment.
This manual is protected by copyright. All rights reserved. It may not be copied, reproduced, abbrevi-
ated or transmitted, neither in whole nor in parts, in any form, neither mechanically nor electronical-
ly, without the previous consent of the manufacturer. © 2018
Meaning
Process failed or duty
cycle limit reached
Device defective
Test indication
Solution
Retry.
Observe the information in your app or contact
your specialist dealer.
You can proceed after the test indication has gone
out.
Disposal
25