Descargar Imprimir esta página

Setting Up Your Oven; Names Of Oven Parts And Accessories; Installation And Connection; Turntable Installation - Hotpoint Ariston FMO 122.1 X Libro De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 33

SETTING UP YOUR OVEN

Names of Oven Parts and Accessories

GB
Remove the oven and all materials from the carton and
oven cavity.
Your oven comes with the following accessories:
Glass tray
Turntable ring assembly
Instruction Manual
F
G
Grill Rack( Only for Grill series )

Turntable Installation

a.
Never place the glass tray upside down. The glass
tray should never be restricted.
b.
Both glass tray and turntable ring assembly must
always be used during cooking.
c.
All food and containers of food are always placed on
the glass tray for cooking.
d.
If glass tray or turntable ring assembly cracks or
breaks, contact your nearest authorized service
center.
Hub (underside)
Glass tray
Turntable shaft
128
1
1
1
A
E
D
C
B
A) Control panel
B) Turntable shaft
C) Turntable ring assembly
D) Glass tray
E) Observation window
F) Door assembly
G) Safety interlock system
Turntable ring assembly

Installation and connection

1.
This appliance is only intended for domestic use.
2.
This oven is intended for built-in use only. It is not
intended for counter-top use or for use inside a
cupboard.
3.
Please observe the special installation instructions.
4.
The appliance can be installed in a 60cm wide wall-
mounted cupboard(at lease 55cm deep and 85cm off
the floor).
5.
The appliance is fitted with a plug and must only be
connected to a properly installed earthed socket.
6.
The mains voltage must correspond to the voltage
specified on the rating plate.
7.
The socket must be installed and connecting cable
must only be replaced by a qualified electrician. If the
plug is no longer to accessible following installation,
an all-pole disconnecting device must be present on
the installation side with a contact gap of at lease
3mm.
8.
Adapters,multi-way strips and extension leads must
not be used. Overloading can result in a risk of fire.
The accessible surface may be hot
during operation.

Publicidad

loading