Installation - Sub-Zero UC-15IPO Guia De Instalacion

IN S TA L L AT I O N

Installation

IN S TA L L I CE M A K E R
Adjust the leveling legs close to the desired height. Refer
1
to the illustration below.
Reverse the door swing if needed. Refer to steps out-
2
lined on page 9.
Gravity Drain Model: Install the drain hose provided onto
3
the drain fitting on the back of unit and route to the open
site drain. Refer to the illustration below and plumbing
requirements on the previous page.
Drain Pump Model: Route the drain tubing through the
drain fitting on the back of the unit and install the drain
hose provided on the drain pump. Route the other end of
the drain tubing to the drain site. Refer to the illustration
below and plumbing requirements on the previous page.
Use a compression fitting to connect the water inlet on
4
the back of ice maker to the prepared
water line. Refer to the illustration below.
LEVELING
LEG
Leveling
1 / " (6) OD cold
4
DRAIN FITTING
WATER INLET
Drain connection
Open the shut-off valve on the water line. Check all
5
plumbing connections for leaks. Failure to do so could
result in flooding.
Plug the power cord into the grounded receptacle.
6
Level the ice maker to assure the door closes and seals
7
properly. Place a level on the top of the unit and turn
each leveling leg to raise or lower as needed.
Move the ice maker into its final position.
8
Anchor the ice maker by installing the two flat head
9
screws provided through each hinge. Refer to the illus-
tration below.
ANCHORING
SCREWS
Anchoring
subzero.com | 7