Troubleshooting Tips; Troubleshooting Washer - Kenmore 2671532 Guía De Uso Y Cuidado

Save time and money! Review the charts on the following pages. You may not need to call for service.
Water Possible Causes
Too many suds Too much detergent
Water leaks Using too much detergent
Fill hoses or drain hose is improp-
erly connected
Household drain may be clogged
Constant water pressure to the fill
hoses at the water source
Water temperature Cooler water temperatures provide
seems incorrect improved energy efficiency
Water supply is turned off or im-
properly connected
Water valve screens are stopped
up
House water heater is not set prop-
erly
Water pumped out Lid lifted or cycle was put in pause
before cycle is for over 24 hours
complete
Water won't drain Drain hose is kinked or improperly
connected
Washer pauses dur- This is normal
ing spin cycle
Can hear but not This is normal
see water at the
end of the cycle
14
BEFORE YOU CALL FOR SERVICE...

Troubleshooting Tips

What to do
Measure your detergent carefully. Use less soap if you have soft
water, a smaller load or a lightly soiled load.
Use less detergent. Use less soap if you have soft water, a smaller
load or a lightly soiled load.
Make sure hose connections are tight at faucets and rubber
washers are installed. Make sure end of drain hose is correctly
inserted in and secured to drain facility.
Check household plumbing. You may need to call a plumber.
Tighten hoses at the faucets and turn the water off after each
use. Check condition of the fill hoses; they should be replaced
every 5 years.
New laundry detergents have been formulated to work with
cooler water temperatures without affecting wash performance.
Turn both hot and cold faucets fully on and make sure hoses are
connected to correct faucets.
Turn off the water source and remove the water connection hoses
from the upper back of the washer. Use a brush or toothpick to
clean the screens in the machine. Reconnect the hoses and turn
the water back on.
Make sure house water heater is delivering water at 120° F
(48° C).
Reset cycle.
Straighten drain hose and make sure washer is not sitting on it.
Top of drain outlet should be less than 8 ft (2.5 m) above floor.
The washer may pause during the spin cycle to remove soapy
water more efficiently.
The pump leaves a little water in its intake and this is diluted
with clean rinse water.