Remaining Risk Factors; Assembly; Preparatory Activities; Delivery Content - HOLZMANN MASCHINEN D 460FXL Manual De Instrucciones

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention
is required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk
factors totally. The following hazards may arise in connection with the machine´s construction
and design:
 Risk of injury to the hands / fingers by the rotating workpioece during operation.
 Risk of injury due to sharp edges of the workpiece, especially in non-fixed with a
suitable tool / device workpiece.
 Risk of injury: hair and loose clothing, etc. can be captured and wound up! Safety
regulations must be observed with regard to clothing.
 Risk of injury due to contacting with live electrical components.
 Risk of injury due to dust emissions, treated with harmful agents workpieces
 Risk of injury to the eye by flying debris, even with safety goggles.
 Risk of injury to the hearing by prolonged labor without hearing protection.
 Risk of injury due to kickback:
Kickback is a sudden reaction. This causes the ejection of the tool to the direction of
the operator.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge
and experience.
12

ASSEMBLY

12.1.1 Delivery content

Please check the product contents immediately after receipt for any eventual transport damage
or missing parts. Claims from transport damage or missing parts must be placed immediately
after initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.

12.1.2 Workplace requirements

The workplace has to fulfill the requirements.
The ground has to be even, in level and hard. It must be suitable at least to weight it with double
weight per square meter than the machines net weight.
The chosen workplace must have access to a suitable electric supply net hat complies with the
machines requirements.

12.1.3 Preparation of the surface

Uncoated metal machine parts have been insulated with a greasy layer to inhibit corrosion.
This layer has to be removed. You can use standard solvents that do not damage the machine
surface.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
11.3
W A R N I N G
12.1
Remaining
risk factors
Preparatory
activities
29
D 460FXL