Tabla de contenido
Publicidad
Rear Belt
Cover
Couvre-
courroie
arrière
Front Belt
Cubierta
Cover
de la correa
Couvre-courroie
trasera
avant
Front Belt
Cover
Motor Shaft
Arbre
d'entraînement
du moteur
Eje del motor
+
Groove
Ouverture
Ranura
Replacing Belt
+
+
Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
Install New Belt
Poser la nouvelle courroie
Instalación de la correa
+
End Cap
Bouchon
Tapa del extremo
Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
Remove lower plate.
Rotate rear belt cover open and
remove front belt cover.
Remove agitator by carefully lifting
out.
Remove worn or broken belt.
Clean agitator.
Loop new belt (Panasonic Type UB4
only) around motor shaft and agitator
pulley; see illustration for correct
belt routing.
Reinstall agitator back into nozzle
housing grooves.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Rotate rear belt cover closed and
reinstall front belt cover.
Reinstall lower plate.
- 30 -
Publicidad
Tabla de contenido
