Troubleshooting - Spengler OXYSTART Manual Del Usario

9. Troubleshooting

Problem
The SpO and Pulse
2
Rate cannot be
displayed normally
The SpO and Pulse
2
Rate are not displayed
as stable
The device cannot be
turned on
The display suddenly
goes out
44
Oxystart® - EN
Possible Cause
1. The patient's finger is not properly
positioned.
2. The patient's SpO is too low to be
2
detected.
1. The finger is not inserted far enough
into the device.
2. The finger is shaking or the patient
is moving..
1. The batteries are drained or almost
drained.
2. The batteries are not inserted
properly.
3. The device has malfunctioned.
1. The device will power off
automatically when no signal is received
after 5 seconds.
2. The batteries are almost drained.
Solution
1. Correctly position the finger and
try again.
2. Try again; Go to a hospital for
diagnosis if you are sure the device is
working properly.
1. Correctly position the finger and
try again.
2. Keep the patient still
1. Change the batteries.
2. Reinstall the batteries.
3. Contact your local service center.
1. This is normal.
2. Change the batteries.