Trouble Shooting - KOBE Brillia Serie Instrucciones De Instalación Y Manual De Operación

TROUBLE SHOOTING

Issue Possible Cause
After The power is not on.
Installation,
both motors
and lights are
The wire connection is not secure.
not working.
The control panel and processor
board wiring are disconnected.
The control panel and processor
board is defective.
Lights are The motor(s) is defective.
working, but
The capacitor(s) is defective.
motor(s) is not.
The control panel or processor
board is defective.
The range The blower system is not secure.
hood is
vibrating.
The turbine impeller/squirrel cage is
not balanced.
Hood is not secured in place.
The motor is LED driver is defective
working, but
LED light fixture(s) is defective
the lights are
not working.
The light wiring(s) is loose.
The control panel or processor
board is defective.
The range The range hood is installed outside
hood is not of the manufacture recommended
venting out clearance.
correctly.
There is no make-up air inside the
house.
Obstacle blocking the pipe work.
The pipe size is smaller than the
suggested pipe size.
Cold air is The pipe connection is not properly
coming into the sealed.
home.
The damper is not properly installed
or is missing from the installation.
The damper is not installed.
Solution
Make sure the circuit breaker and the unit's
power is ON. Use a voltage meter to check
the power supply.
Check and tighten wire connection.
Check wire continuity from control panel to
processor board.
Replace the control panel or processor
board.
Replace the motor.
Replace capacitor(s).
Replace the control panel or processing
board.
Tighten the turbine impeller/squirrel cage
and air chamber.
Replace the turbine impeller/squirrel cage.
Check the installation of hood, tighten the
mounting bracket.
Replace LED Driver
Replace LED light fixture(s)
Check wire continuity from processor board
to light transformer to LED light fixture(s).
Replace the control panel or processing
board.
Adjust the clearance between the range
hoods and cook top to 26" to 30". For Island
range hood, the clearance between the
range hoods and cook top is 30" to 36".
Open the window to enhance the
performance of the range hood by creating a
sufficient make-up air.
Remove all obstacles from the duct work.
Change the ducting according to the
manufacture suggestion.
Check the pipe installation.
Check the damper installation.
Installing the damper will help eliminate air
backflow.
18