Utilisation; Water Connection - Polytropic R-PAC 31 Manual De Instrucciones

Polytropic

Utilisation

Water connection

Warning, the by-pass must be fixed on a wall or on a support, so that by-
pass and tubes weight is not supported by the heat pump connexions!
After connecting water to the pool system, complete with a suitable by-pass and
electrical connections by a qualified engineer:
Be sure that:
• Appliance is horizontal and on a firm base.
• Water circuit is well connected (no leaks and no chance of injury due to
badly fitted hydraulic couplings).
• Electrical circuit is well connected (all cables tightened correctly at
terminals and intermediate circuit breaker), insulated and earthed correctly.
• The installation requirements described previously are strictly adhered to.
You can then start your machine. (Follow every point in the below order each
time you start the pool heat pump, especially at the beginning of a season):
By-pass diagram
30