Set-Up Instructions - Victoria Arduino ATHENA Serie Manual Técnico De Empleo

SET-UP INSTRUCTIONS

After having checked that nothing fails in the
packaging, put the machine in the place fore-
seen and pay attention that it is level by adju-
sting the pins. If the extension pins are fore-
seen, the assembling will be carried out by
untwisting completely the pin and twisting it
back again on the metal insert supplied with
the extension, then put the cylindrical shell
made of plastic on the insert.
Place the softener in the space foreseen. We
remind that for the VICTORIA ARDUINO
ATHENA SEMIAUTOMATIC the pump is built-
in the machine itself, so the fastening opera-
tions will be extremely simplified.
Remark: to guarantee a better reliability of
the pump, it is necessary to install a net filter
20
between the softener and the machine, avoi-
ding that impurities, like sand, scale suspen-
ded particles, rust etc. damage the delicate
surfaces made of graphite.
It is advisable anyway, before performing the
plumbing connection of the machine, let
water go through the softener to eliminate
possible impurity or greasy deposits.
The machine must always be protected with
an automatic switch of adequate power.
The Company is not responsible for any
damage caused to things or people deriving
from failing the safety regulations' observan-
ce.
For a good performance of the machine, the
net pressure must not more than 4 bar, in dif-
ferent cases do install a pressure reducer over
the softener. The entering water pipe must
have an internal diameter not inferior to 8
mm.
Remark: before connecting the machine
electrically, check that the voltage stated on
the plate of the machine's data corresponds
to the net's one; otherwise proceed to the
appropriate and necessary change.
STARTING
Even if all the machines VICTORIA ARDUINO
have an automatic level, it's good rule, in the
initial phase, to fill the boiler manually to avoid
that the electric resistance is damaged and the
electronic safety is connected (this one stucks