Important; Cleaning & Disinfecting Your Lumineb Ii - Lumiscope LUMINEB II Instrucciones De Operación

IMPORTANT:

The compressor motor has a thermal protector which will shut off the unit before
it overheats. When the thermal protector shuts the unit off:
1 . Switch off the LUMINEB II .
2 . Unplug the unit from the electrical outlet .
3 . Wait 30 minutes for the motor to cool down before another treatment .
4 . Make sure the air openings are not obstructed .
CLEANING YOUR LUMINEB II
It is recommended that the nebulizer, mouthpiece and mask are thoroughly
cleaned with hot water after each use and cleaned with mild detergent after the
last treatment of the day . If your physician or respiratory therapist specifies a
different cleaning procedure, follow their instructions .
Before cleaning, make sure the power cord is disconnected from the electrical
outlet and the unit .
To clean your LUMINEB II:
1 . Disconnect the air tube, nebulizer and mouthpiece .
2 . Gently twist the nebulizer to open it .
3 . Rinse the nebulizer and mouthpiece or mask with water .
4 . Dry with a clean soft towel or allow to air dry .
5 . Reassemble the nebulizer when completely dry .
6 . Wipe the compressor with a damp cloth and allow to air dry .
7. Never use powdered cleaners or soap pads on the compressor, as it may
damage the finish of the unit .
DISINFECTING YOUR LUMINEB II
It is suggested that your LUMINEB II be disinfected after the last treatment of
each day. Unless indicated otherwise by your physician, disinfect your LUMINEB II:
5710-INS-LAB-RevB14 8