Reviewing Test Results; Reviewing Blood Glucose Day Average Results; Bluetooth Transmission; Maintenance - VISIOMED BewellConnect MyGluco BW-GL1 Manual De Usuario

7.1. REVIEWING TEST RESULTS

1. Press and release M.
" will appear on the display. Press M again, and the first reading you see is the
"
last blood glucose result along with date, time and the measuring mode.
2. Press UP or DOWN to recall the test results stored in the meter each time you
press. After the last test result, press M again and the meter will be turned off.

7.2. REVIEWING BLOOD GLUCOSE DAY AVERAGE RESULTS

1. Press and release M. When "
seconds until the flashing "
result measured in general mode will appear on the display.
2. Press M to review 14-, 21-, 28-, 60- and 90- day average results stored in memory.
3. Exit the meter memory.
Keep pressing the M and the meter will turn off after displaying the last test result.
NOTE:
• Any time you wish to exit the memory, keep pressing M for 5 seconds or leave it without any
action for 3 minutes. The meter will switch off automatically.
• Control solution results are NOT included in the day average.

8. BLUETOOTH TRANSMISSION

To transmit your measure on your smartphone or tablet, open the application MyGluco
and open the measurement screen. Turn on the Bluetooth function on your smartphone or
tablet and activate the bluetooth mode on the glucose monitor.
There are two ways to activate the Bluetooth mode of the MyGluco and transmit the data to
your app. After the end of the measurement (the result is displayed on the screen) :
1. Keep the strip in the slot, and press the M button on the bottom left.
OR
2. Eject the strip by pushing up the Strip-Ejection button or remove the strip directly by
your hand.
After following this step (1 or 2), "OFF" is shown and the Bluetooth mode is activated :
The blue LED (top right) will begin to blink, once the connection between the meter and
device is established, the blue LED will stop blinking and stays on permanently. The data is
transmitted to the app.

9. MAINTENANCE

9.1 BATTERY

Your meter comes with two 1.5V AAA size alkaline batteries.
" appears on the display, keep pressing M for 3
" appears. Release M and then your 7-day average
BewellConnect - BW-GL1 - User Manual - 052015 37