Sage Bambino Plus Guía Rápida página 10

PAGE HEADER..... OPERATING YOUR NEW APPLIANCE
• Wipe excess coffee from the rim of the filter
basket to ensure a proper seal is achieved in
the group head.
PURGING THE GROUP HEAD
Before placing the portafilter into the group
head, run a short flow of water through the
group head by pressing the 1 CUP button. This
will stabilise the temperature prior to extraction.
INSERTING THE PORTAFILTER
Place the portafilter underneath the group head
so that the handle is aligned with the INSERT
position. Insert the portafilter into the group
head and rotate the handle towards the centre
until resistance is felt.
INSERT
+
Place your cup/s under the portafilter on the drip tray.
PRE-PROGRAMED SHOT VOLUME
– 1 CUP
Press the 1 CUP button once, the button will flash
indicating that it has been selected. A preset single
espresso volume of approximately 30mls will be
extracted. The machine will automatically stop
once the pre-set volume has been extracted.
10
LOCK
2s
+
PRE-PROGRAMED SHOT VOLUME
– 2 CUP
Press the 2 CUP button once, the button will
flash indicating that is has been selected. A
preset single espresso volume of approximately
60mls will be extracted. The machine will
automatically stop once the pre-set volume has
been extracted.
NOTE
Pressing the 1 CUP or 2 CUP buttons
during a programmed espresso will
immediately stop the extraction.
MANUAL PRE-INFUSION AND SHOT VOLUME
+
Press and hold the 1 CUP or 2 CUP button for the
desired pre-infusion time. Release the button to
start the extraction. Press the flashing button again
to stop the extraction.
PROGRAMMING SHOT VOLUME
Press and hold the 1 CUP and 2 CUP buttons for 2
seconds, the buttons will illuminate and flash.
+
To set the 1 CUP volume:
• Press the 1 CUP button to start the extraction.
• Press the 1 CUP button again to stop the
extraction. The modified volume will be saved.
To set the 2 CUP volume, follow the above steps
but select the 2 CUP button to start and stop
the extraction.
2s
OFF
2s