• ALWAYS turn water supply "ON" before turning pressure washer "ON." Running pump dry causes serious
damage.
• Do not operate the pressure washer with the inlet water screen removed. Keep screen clear of debris and
sediment.
• NEVER operate pressure washer with broken or missing parts. Check equipment regularly and repair or
replace worn or damaged parts immediately.
• Use only the nozzle supplied with this machine.
•Never leave the wand unattended while the machine is running.
•Never attempt to alter factory settings. Altering factory settings could damage the unit and will void the
warranty.
• Always hold gun and wand firmly when starting and operating the machine.
• NEVER allow the unit to run with the trigger released (off) for more than one (1) minute. Resulting heat
buildup will damage pump.
• Pressure washer is not supposed to pump hot water. NEVER connect it to a hot water supply as it will
significantly reduce the life of the pump.
• NEVER store the pressure washer outdoors or where it could freeze. The pump will be seriously damaged.
• Release trigger when changing from high to low pressure modes. Failure to do so could result in damage.
• Be aware of the recoil caused by the water jet when the machine is switched on.
CAUTION: Keep hose away from sharp objects. Bursting hoses may cause injury. Examine hose regularly and
replace it if damaged. Do not attempt to mend a damaged hose.
EXTENSION CORDS
The use of an extension cord is not recommended. Use only extension cords intended for outdoor use.
These are identified by the mark "Acceptable for use with outdoor machines; store indoors while not in
use." Use only extension cords having an electrical rating equal to or more than the rating of the machine.
Do not use damaged extension cords. Examine
extension cord before using and replace it if damaged. Do not abuse extension cord. Do
not pull on the cord to disconnect. Keep cord away from heat and sharp edges.Always disconnect cord from
receptacle before disconnecting machine from extension cord.
DANGER!
Failure to follow these instructions can result in serious injury, including death.
WARNING! To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch
plug with wet hands.
Machines shall not be used by children. Children should be supervised to ensure that they do not play with
the machine
This machine is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge.
WARNING! This machine has been designed for use with the cleaning agent supplied or recommended
by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the
machine.
WARNING! High pressure jets can be dangerous if subject to misuse. The jet must not be directed at
persons, live electrical equipment or the machine itself.
WARNING! Do not use the machine within range of persons unless they wear protective clothing.
WARNING! Do not direct the jet against yourself or others in order to clean clothes or foot-wear.
WARNING! Risk of explosion-Do not spray flammable liquids.
WARNING! High pressure cleaners shall not be used by children or untrained personnel.
WARNING! High pressure hoses, fittings and couplings are important for the safety of
the machine. Use only hosed, fittings and couplings recommended by the manufacturer.
WARNING! To ensure machine safety, use only original spare parts from the manufacturer or approved by
the manufacturer.
WARNING! Water that has flown through backflow preventers is considered to the non-potable.
WARNING! The machine shall be disconnected from its power source by removing the plug from the socket-
outlet during cleaning or maintenance and when replacing the machine to another function.
WARNING! Do not use the machine if a supply cord or important parts of the machine are damaged, e.g.
safety devices, high pressure hoses, trigger gun.
WARNING! If an extension cord is used, the plug and socket must be of watertight construction.
4
GB
WARNING! Inadequate extension cords can be dangerous. If an extension cord is used, it shall be suitable
for outdoor use, and the connection has to be kept dry and off the ground. It is recommended that this is
accomplished by means of a cord reel which keeps the socket at least 60mm above the ground.
WARNING! In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance
must not be supplied through an external switching device, such as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
Warning symbol: Machine not suitable for connection to the potable water mains.
WARNING! The machine is intended to be used at a temperature above o degree. (Only for machine with
power cord of H05VV-F).
WARNING! To ensure the machine safety, please only use original spare parts (including nozzle) from the
manufacturer or approved by the manufacturer. Do not use the machine before you changed them if they
are amaged.
WARNING! Be care of the danger of the kickback force on the spray assembly when
opening the trigger gun and grasp the gun with hands firmly.
WARNING: When the machine is moving and installing, the machine must be in flat. When moving the
machine, pulling the handle to move it.
WARNING! Connect to the water supply.
The machines are not suitable for connection to potable water mains. Connect the machine to the water
supply. (It can be a water container).Make sure the inlet water pressure keeps between 0.01MPa and
0.4MPa.Do not use the pipe if the pipe is damaged. If you want connect this machine to portable water
mains, you must install a backflow preventer in the water pipe to prevent dirty water flow back to the
drinking water system. The backflow preventer shall comply with EN 60335-2-79 ANNEX AA.
WARNING! Disconnect from the electrical power supply before carrying out user maintenance.
If the mains cable is damaged it must be replaced by the manufacturer, or its service agent or similarly
qualified person to avoid a hazard.
Connection
1. Attach the high pressure hose to the pressure water outlet of the machine.
2. Attach the spray handle to the high pressure hose. Prior to operating the machine please ensure that the
high pressure hose has been completely uncoiled. Whilst the machine is in operation the hose MUST not
loop.
3. Mount the nozzle or any other equipment you want to use.
4. Connect the machine to the water and power supplies.
SYMBOLS
Read the manual
Warning
Double isulation
Wear eye protection
OPERATING INSTRUCTION
1. pressure cleaner 2. water supply hose
3. water connection 4. water inlet
5. high pressure tube 6. water outlet
7. spray gun
8. power supply
Wear ear protection
Do not dispose of old appliances in the
household garbage
GB
5