Lubricate The Crimping Unit; Servicing The Compressed Air Maintenance Unit - Weidmuller Power Crimper 6.0 Manual De Instrucciones Original

Cleaning and maintaining the machine

6.4 Lubricate the crimping unit

Potential risk of fatality due to electric
shock!
When working on the inside of the machine,
non-insulated parts may be touched.
► Switch the machine off.
► First remove the compressed air hose
from the compressed air source, then from
the maintenance unit.
► Pull the power plug.
► Remove the four mounting screws of the housing.
► Lift the housing upwards.
► Disconnect the ground wire from the housing.
2
3
4
► Lubricate the crimp wedge (1) with grease on all sides.
► Lubricate all rollers (2), pivot points (3) and sliding sur-
faces (4).
► Reconnect the ground wire to the housing.
► Replace the housing.
► Tighten all four fixing screws.
18
WARNING
6.5 Servicing the compressed air mainte-
nance unit
Risk of injury posed by electrical volt-
age!
► Make sure that the machine is switched off
and the mains plug has been pulled.
Risk of injury posed by compressed air
hoses swinging around!
► Make sure that the compressed air hose
is disconnected from the compressed air
source.
1
3
2
1
Figure 6.2 Compressed air maintenance unit
As required
► To drain the condensate press the drain plug (1) up-
wards.
► To change the filter, unscrew the condensate tank (2)
and screw off the filter (3).
► Insert a new filter and screw the condensate tank back
on tightly.
CAUTION
CAUTION
2639590000/00/11.2018