3
b. Outdoor station, exterior camera
1. Auto focus C-MOS camera lens
2. Speaker: allows to be heard outside.
3-4. Name holder (illuminated after call) and call button: when pressing
this button, the internal units ring, the camera and the monitor start
working.
5. Microphone: enables the visitor to communicate with the internal unit.
6. White LED lighting : enables seeing the visitor even in a low light en-
vironment. (visitor at a distance lower than 30 cm. Beyond this distance,
use an additional lighting).
7. Twilight cell.
4
INSTALLING
N.B. :
If you try your product before installing it, please be sure not to do it with the roadside panel and the
monitor in the same room, otherwise the video door phone will produce a shrill sound
a. Installing of outdoor station (camera)
1.Flush mount the plastic box (3) taking care not to block the locking nuts of the roadside panel.
2. Remove the 2 screw covers (4) with a small screwdriver to put in the notch (5)
3. Plug the connecting wire observing the wiring diagram (page 6)
4. Fix the roadside panel on the flush-mounted box with 2 special screws supplied (2)
5. Install the 2 screw covers (4)
Caution :
Do not expose the camera to direct sun light or to reflective surface. As the camera is flush-mounted,
we strongly advice you to protect it from the rain with an inclined tile or any other mean.
Put a silicon gasket on the upper half between the external panel and the wall (6)
1.60m
4GB
5 7 4 8 6
2
4
1
5
CFI EXTEL WEVP 629 - 12/2009 - V1
9
2
1
1
7
2
3
6
5
3
4
5
6
4
(Larsen effect)
2