Fitting/Removing Brush Heads - Nevadent NAZ 2.4 C3 Instrucciones De Uso

3) Open the lid 0 of the brush holders q and place the replacement brush
heads in the four slots provided . Close the lid 0 again .
4) Place the handset on the charger 8 so that it slides onto the pin on the
base .
5) Allow the handset to charge up for around 14–16 hours before using it for
the first time . The charging light 7 on the front of the handset lights up red
during the charging process .
6) Use the handset repeatedly without charging the battery until the perfor-
mance becomes noticeably weaker or the toothbrush stops working and
the charge indicator 7 flashes red . Then recharge the battery for 14–16
hours . When the appliance is fully charged, the charge indicator 7 lights up
green .
7) Charge and discharge the toothbrush completely 3 times . The battery will
have then reached its full capacity .
8) You can now leave the handset in the charger 8 after every use, so as to
always have full power available .

Fitting/removing brush heads

■ To remove the brush head 1, pull it upwards and off the drive shaft 2 .
■ When fitting the brush head 1, ensure that the drive shaft 2 on the handset
slides precisely into the socket on the brush head 1 .
Push the brush head 1 down until it completely covers the drive shaft 2 .
NOTE
You can order replacement brush heads from our Service department
(see section "Ordering replacement parts") .
You can also use the brush heads for the models NAZ 3 .7 A1 and
DAZD 3 .7 LI B2 (also available from Lidl) .
The toothbrush is also compatible with brush heads from the following
©
Oral B
Oral-B Ortho, Oral-B Precision Clean, Oral-B 3D White, Oral-B Cross
Action, Oral-B Stages Power, Oral-B Sensitive, Oral-B Deep Cleaning .
*Oral-B is a registered trademark of Procter & Gamble .
■ 20 │ GB │ IE
* models:
NAZ 2.4 C3