Stihl FS 45 Manual De Instrucciones página 21

English / USA
10
11
5
STIHL Polycut 6-3
: Fit the thrust plate on the shaft.
: Insert mounting nut (10) in the
mowing head.
: Screw mowing head (11) clockwise
onto the shaft (5) as far as stop.
: Block the output shaft with the stop
pin.
: Tighten down the mowing head.
Remove the tool used to block the
shaft.
20
Blocking the shaft
: Block the shaft by pushing the stop
pin (12) through the holes (13) in the
deflector and thrust plate – turn the
thrust plate back and forth if
necessary.
: Tighten down the mowing head
firmly.
Remove the tool used to block the
shaft.
5
4
3
1
STIHL FixCut 5-2
: Fit the thrust plate (2) on the shaft.
: Place the mowing head on the
thrust plate (2).
Collar (arrow) must locate in the
mowing head's mounting hole.
: Push the thrust washer (3) over the
shaft (1) so that it locates against
the base.
: Block the output shaft.
: Use the combination wrench (5) to
screw the mounting nut (4)
counterclockwise onto the output
shaft and it tighten down firmly.
Remove the tool used to block the
shaft.
FS 45, FS 46
2