Additional Safety Rules; Safety Instructions For All Op- Erations - Panasonic EY4640 Manual De Instrucciones

II. ADDITIONAL
SAFETY RULES
Safety instructions for all op-
erations
Safety warning common for Grinding
or Abrasive Cutting-off operations:
1) This power tool is intended to
function as a grinder, or cut-off
tool. Read all safety warnings,
instructions, illustrations
specifications provided with this
power tool. Failure to follow all in-
structions listed below may result in
electric shock, fire and/or serious
injury.
2) Operations such as sanding,
wire brushing, polishing are not
recommended to be performed
with this power tool. Operations
for which the power tool was not
designed may create a hazard and
cause personal injury.
3) Do not use accessories which
are not specifically designed and
recommended by the tool man-
ufacturer. Just because the ac-
cessory can be attached to your
power tool, it does not assure safe
operation.
4) The rated speed of the accessory
must be at least equal to the
maximum speed marked on the
power tool. Accessories running
faster than their RATED SPEED
can break and fly apart.
5) The outside diameter and the
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately
guarded or controlled.
6) The arbour size of wheels, flanges,
backing pads or any other ac-
cessory must properly fit the
spindle of the power tool. Acces-
sories with arbour holes that do not
match the mounting hardware of
the power tool will run out of bal-
ance, vibrate excessively and may
cause loss of control.
7) Do not use a damaged accessory.
Before each use inspect the ac-
cessory such as abrasive wheels
for chips and cracks. If power tool
or accessory is dropped, inspect
for damage or install an unda-
maged accessory. After inspect-
ing and installing an accessory,
position yourself and bystanders
away from the plane of the rotat-
ing accessory and run the power
tool at maximum no-load speed
for one minute. Damaged acces-
and
sories will normally break apart dur-
ing this test time.
8) Wear
equipment. Depending on ap-
plication, use face shield, safety
goggles or safety glasses. As
appropriate, wear dust mask,
hearing protectors, gloves and
workshop
stopping
workpiece fragments. The eye
protection must be capable of
stopping flying debris generated
by various operations. The eye
protection must be capable of
stopping flying debris generated by
various operations. The dust mask
or respirator must be capable of fil-
trating particles generated by your
operation. Prolonged exposure to
high intensity noise may cause
hearing loss.
9) Keep bystanders a safe distance
away from work area. Anyone
entering the work area must wear
personal protective equipment.
Fragments of workpiece or of a
broken accessory may fly away and
cause injury beyond immediate area
of operation.
10) Hold power tool by insulated grip-
ping surfaces only, when perform-
ing an operation where the cutting
accessory may contact hidden wir-
ing or its own cord. Cutting acces-
sory contacting a "live" wire may
make exposed metal parts of the
power tool "live" and shock the op-
erator.
- 10 -
personal protective
apron capable
small abrasive
of
or