Panasonic EY4640 Manual De Instrucciones página 16

15º-30º to the workpiece surface.
When using a new grinding disc, do not
work the grinder in the B direction or it will
cut into the workpiece. Once the edge of
the grinding disc has been rounded off by
use, the grinding disc may be worked in
both A and B direction.
Using a cut-off disc guard
(EY9X213E) (Available as an
accessory, not included)
Make sure the side.
WARNING:
• When using an abrasive cut-off
disc, be sure to use only the cut-off
disc guard designed for this use
with cut-off disc.
• NEVER use cut-off disc for grinding.
• Do not jam the Disc or apply ex-
cessive pressure. Do not attempt
to make an excessive depth of cut.
Overstressing the cut-off disc in-
creases the loading and suscepti-
bility to twisting or binding of the
cut-off disc in the cut and the pos-
sibility of kickback, cut-off disc
breakage and overheating of the
motor may occur.
• Do not start when disc is in the
workpiece. To do so causes the
cut-off disc binding or kickback. Let
the cut-off disc reach full speed and
then carefully cut the workpiece.
• During cutting operations, never
change the angle of the disc. Plac-
ing side pressure on the cut-off
disc (as in grinding) will cause the
disc to crack and break, causing
serious personal injury.
CAUTION:
• To prevent excessive temperature
increase of the tool surface, do not
operate the tool continuously us-
ing two or more battery packs. The
tool needs cool-off time before
switching to another pack.
• Do not close up ventilation slots on
the sides of the body during operation.
Otherwise, the machine function is
adversely affected to cause a failure.
• Do NOT strain the tool (motor). This
may cause damage to the unit.
• Use the tool in such a way as to
prevent the air from the ventilation
slots from blowing directly onto
your skin. Otherwise, you may get
burned.
Indicator lamp for On lock
warning lamp function
The grinder will not start when the
switch is at the ON position (switch
lever at ON), even when the battery
pack is inserted. The warning lamp
will flash at this time to indicate that
the on lock start prevention function
has operated.
Press the switch to the OFF position
(switch lever at OFF) and then press
it back to the ON position (switch
lever at ON) to start the grinder.
ON
- 16 -
OFF