Operating Informations; Maintenance And Care - Flex XFE 7-15 Instrucciones De Funcionamiento

Instruction manual
To set the operating speed, move the dial to
the required value.
– 1 = lowest speed
– 6 = highest speed
Gently press the switch (5) to accelerate the
power tool up to the preselected speed.
NOTE
If an overload or overheating occurs during
continues operation, the power tool
automatically reduces the speed until the
power tool has cooled down adequately.

Operating informations

CAUTION
When the power tool is switched off,
the polishing tool continues running briefly.
NOTE
Following a tool change (e.g. wool pad
instead of polishing sponge), the difference
in weight may increase the vibrations.
Change the operating speed with the
adjusting wheel (4) until the vibrations have
been reduced.
– Switch on the machine before placing it
on the surface which is to be polished and
run the polisher up to the set speed.
12
– Applying light contact pressure, move the
polisher in circular, overlapping
movements on the surface which is to be
polished in order to obtain a good
polishing finish and to ensure that the tool
has a long service life.
– On sensitive surfaces (e.g. car paint-work)
do not work aggressively but work at slow
speeds applying low contact pressure.
– If using a polishing paste, use the
respective tool for each paste.

Maintenance and care

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always pull out
the mains plug.
Cleaning
Regularly clean the power tool and venti-
lation slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
CAUTION
Risk of injury! Wear safety glases while
using compressed air.
All plastic parts should be cleaned with soft
damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve
or otherwise damage the material.
XFE 7-15 / XCE 10-8