CDVI Mifare DGM1D Manual De Instrucciones página 16

INSTALLATION MANUAL
DGM1D
1-Door Mifare
®
6] TYPICAL INSTALLATION WITH BUS INTERFACE (INTBUSDGM1D)
IMPORTANT
RECOMMENDATIONS
- Use AC or DC power supply.
- The mawimum distance between
the reader interface and the controller
unit is 50 meters.
- DGM1D time lock is programmable
from 2 to 20 seconds with the
PCV123D handheld terminal.
- If using the DGM1D with the reader
interface (INTBUSDGM1), make sure JP2
jumper is ON.
DGM1D
Terminals
1 ANT Antenna
2 GND Antenna
J2
3 Led R Red LED
4 Led V Green LED
1 B BUS RS 485
2 A BUS RS 485
J1 3 TX PCV123D Link
4 RX PCV123D Link
5 GND PCV123D Link
1 DATAS Data
2 GND Request to exit input (Push button)
J5
3 GND Ground
4 BP Request to exit input (Push button)
1 NO N.O. relay output
2 C Common relay output
J3 3 NC NC relay output
4 12 Input voltage 12V AC/DC
5 V Input voltage 12V AC/DC
cdviberica.com
16
cdvigroup.com
controller/reader system
Description
DGM1D
Wire SYT1 8/10e mm
shield or coaxial (Depend on distance)
Recommended cable:
AWG35 2 pair shielded cable.
Use 1 pair cable to power the controller and
another pair for the data transmission.
EN
GREEN
RED
4 core cable
2
Reader