Clarion NAX943DV Manual De Instrucciones página 12

ClarionNavi_English.book 5 ページ ２００４年３月１９日 金曜日 午後４時１８分
mode:
The navigation screen is always dis-
played and AV sound is heard.
The voice guidance is prioritised at route
guidance points and the AV sound is tem-
porarily switched to the voice guidance.
[NVG+INT MODE] Navigation+interrup-
tion mode:
The AV screen is usually displayed and
AV sound is heard.
The navigation screen and voice guid-
ance are prioritised at route guidance
points and the screen and sound are tem-
porarily switched to the navigation screen
and voice guidance.
[AV MODE] AV mode:
The AV screen is always displayed and
AV sound is heard.
• If you have selected the combination of
English (km) and English (mile) with the
programme CD-ROM, the only choices
you have in this screen are km and mile.
• The language to use can be selected
from 6 languages: English, German,
French, Italian, Spanish, and Dutch.
• In the default settings, the screen to
select either English or German will be
displayed.
• For how to set batteries in the remote
control, refer to page E-35.
• If you want to use a language other than
the languages displayed, reinstallation
using the programme CD-ROM is neces-
sary. Refer to page E-37, "Switching the
language using the programme CD-
ROM".
Language selection using the naviga-
tion system
Switching between the languages displayed
on the SYSTEM START-UP screen can be
done by the procedure below.
⇒[Language]
<Operation with the touch panel>
For models that can be operated with the
touch panel, refer to chapter 13 "SAMPLE
SYSTEM" in the Installation and Wire con-
Read this chapter before using various functions / Getting started
nection manual.
With the touch panel model, you can operate
the navigation system not only by using the
remote control but also by touching keys on
the screen.
1
Start the engine.
2
If you want to change the language,
select the preferred language.
Language selection is completed by
touching keys on the screen.
3
Select the [ENTER] key.
Tips:
In this manual, operation with the remote
control is mainly explained. For the compari-
sons between the remote control and the
control panel, refer to page E-35, "Remote
control, control panel and list of keys".
In cases when the operations between the
remote control and the control panel are sig-
nificantly different, the operation methods for
the control panel are also described.
Setting of the display timeout
You can change the time for the timeout for
automatically returning to the current loca-
tion screen.
The time can be selected from 5, 10, 15, 20,
or 30 seconds. Also, "None", which turns off
the timeout setting, can be selected.
⇒[Display]⇒[Settings Display Timeout]
Deletion of the memory
Stored data in the Address Book, Avoid
Area, and Previous Dest. can be deleted all
at once.
⇒[Navigation]⇒[Clear Mem-
ory]⇒[Yes]⇒[Yes]
E-5