Getting Started; Filling The Reservoir - Waterpik WF-10 Manual De Instrucciones

6

GETTING STARTED

Charging Unit Prior to First Use
Plug the power cord into the wall and place the magnetic charger on the front of the unit for approximately 4 hours (see image). Ensure
contacts are clean/dry before connecting the charger. The LED light will display a single, rapid blink every 3 seconds when unit is fully
charged and the charger is connected. A full charge will last for approximately 1 week of typical use. When the batteries are in need
of charging (approximately 30% charge left) the charge indicator light will blink 8 times quickly after use to indicate that you should
recharge the unit. A complete recharge will take 3-4 hours. If you use your Water Flosser once a day or less, it is recommended you
charge it once a week. If you use it twice a day or more, charge the unit more frequently.

Filling the Reservoir

Remove the magnetic charger from the unit prior to filling reservoir and product use. Lift flip top on reservoir and fill the reservoir with
lukewarm water.
Fill
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. Press firmly until the tip clicks into place. To remove the tip
from the handle, press the tip eject button and pull tip from the handle.
Eject
CAUTION: Do not press tip eject button while unit is running.