Important Safety Information - ERMILA 1247 Instrucciones De Uso

ENGLISH
Description of parts
de A Hair clipper
B Blade set
C Release button for blade set
D On/Off switch (2 settings)
en
E Air filter
F Hang-up loop
G Mains cable
fr
H Cleaning brush
I Oil bottle
it

Important safety information

For your own protection from injuries and electric shocks, the following information must be observed when using electrical equipment:
Read these operating instructions carefully and make sure you understand them before using the appliance!
es
· Only use hair clippers to cut human hair.
Only use animal clippers to cut animal hair and animal fur.
· Only use the appliance for the proper use as described in the operating instructions.
pt
· Keep packaging away from children.
· This appliance is not suitable for use by people (including children) with physical, sensory or mental disabilities or who do not have
the relevant experience or knowledge of using such appliance, unless under the supervision of or after having received instruction in
nl
the use of the appliance by an individual who is responsible for their safety. Children should be supervised to ensure they do not play
with the appliance.
· The operating instructions should be retained so that they can be referred to at a later date and should be passed on to all subse-
quent owners or users of the appliance.
sv
· Only operate the appliance with an alternating current and with the voltage stated on the nameplate.
Warning:
· Do not use the appliance near bath tubs, showers or other water-filled containers. It should also not be used in areas of high
no
humidity. Always disconnect from the mains power supply after use since water can pose a hazard, even when the appliance
is switched off.
· Never touch electrical equipment that has fallen into water.
da
Disconnect from the mains immediately.
· If the appliance is dropped into water, it may not be used again subsequently.
· It is essential to PREVENT electrical equipment from coming into contact with water or other liquids.
fi
· Never use the appliance with wet hands or feet.
· Never use the appliance when barefoot.
· As additional safety measure, it is recommended that a tested residual current appliance (RCD) with a residual operating current of
tr
not more than 30 mA be installed in the bathroom circuit. Ask your electrician for advice.
· Disconnect from the mains before cleaning or servicing the appliance.
· Never use the appliance if it is defective, if it has fallen onto the floor or if the mains cable is damaged. A damaged mains cable may
only be replaced with an original replacement cable by an authorised Service Centre or another similarly qualified person, in order to
pl
avoid hazards.
· Repairs may only be performed at an authorised Service Centre using original parts. Only specialists properly trained in the handling
of electrotechnical appliances may repair electrical equipment.
cs
· Only use accessories recommended by the manufacturer.
· When disconnecting the appliance from the mains, never pull on the mains cable or on the appliance itself.
· Do not hold the appliance by the mains cable to carry it and do not use the cable as a handle.
sk
· Do not wind the mains cable around the appliance.
· Keep the mains cable and appliance away from hot surfaces.
· Make sure that the mains cable is not twisted or kinked when used and stored.
sl
· Never use the appliance where aerosol (spray) products are being used or where oxygen is released.
· Do not expose the appliance to temperatures below 0°C and above +40°C for any length of time. Avoid direct exposure to sunlight.
· The appliance is safety insulated and radio screened. It meets the requirements of EU Directive 2004/108/EC regarding electromag-
ro
netic compatibility and EC Low Voltage Directive 2006/95/EC.
· We are not liable for damage caused as a result of improper use or failure to observe these operating instructions.
Start-up
bg
· Before starting the appliance, always check the lubricating condition of the blade set. Oil the blade set, if and when necessary.
· Only connect the appliance to the socket while it is switched off.
· Connect the mains plug to the socket and switch on the appliance. The appliance has two speed settings.
ru
· Should the cutting process be interrupted, always switch off the appliance.
· After using the appliance, switch it off and remove the mains plug.
uk
Cutting with the attachment comb
The appliance can also be operated with attachment combs. Attachment combs can be used to extend the cutting length range.
Accessories are available from your dealer.
el
6