Victron energy VE Bus Multi Manual página 11

Example for a 230V/4kVA generator (3000 rpm):
A 4kVA/230V generator can supply a maximum current of 17,4A. Using the 70%
safety margin we will set the generator current limit to 12A. To set the
configuration, using either a 16A or 30A panel, do the following:
Press and hold the configuration button until the bottom LED in the left column
•
starts flashing indicating step 1.
This step can be ignored because we assume VE.Bus Multis.
Press the button to go to the next step.
•
(The lower left LED will turn on indicating step 2.)
Determine the value for step 2 by dividing the required generator current by 2.
•
12/2 = (0)6.
Because this is lower than 10 the value to be set during step 2 is 0.
The value to be set during step 3 is 6.
Turn the knob until all LEDs in the right columns are off. Setting the value for step
•
2 to 0.
Press the button to go to step 3.
•
Turn the knob until the bottom 3 LEDs in the right columns are on. Setting the
•
value for step 3 to 6.
Press the button to finalize the configuration.
•
7