Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEMS
CAUSES
Coffee overflowing
Residues of ground coffee have
from the edges of
remained on the gasket of the
the filter ring
filter holder coupling seat.
The hole of the silicone disc is
clogged.
Coffee overflowing
The exit holes of the filter con-
from the edges of
taining coffee grounds are
the filter ring.
clogged.
Faulty pod.
The coffee is not
The holes of the perforated disc
supplied or flows
in the filter holder coupling seat
too slowly.
are clogged.
The spring in the centre of the
filter holder coupling seat is
blocked by lime.
The exit holes of the filter con-
taining coffee grounds are
clogged.
The coffee blend is ground too
fine.
The coffee blend is pressed
down too much.
The tanks is not inserted well.
The hole of the silicone disc is
clogged.
There is little water and the
pump does not suck it up.
Faulty pod.
Broken pod.
The coffee is too
The blend has been ground too
watery and cold.
coarsely.
SOLUTIONS
Clean the seal with a toothpick or a sponge (Fig. 13).
Wash the silicone disc (E) under running water,
bending it slightly on the sides in order to free the
centre hole of any residue of coffee grounds that
could clog it (Fig. 12).
Slowly remove and disconnect the filter holder be-
cause any remaining pressure could cause splashes
or squirts. Clean the clogged filter holes with a small
brush or a pin..
Replace the pod in the filter holder (K).
Turn on the machine without the filter holder, making
the water run. If the water still does come out from
all the holes evenly, carry out the descaling cleaning
operation.
Loosen the screw in the centre of the filter holder
coupling seat with a 5 mm hex wrench (Fig. 14). Re-
move the spring. Put the spring to soak in a descal-
ing solution in order to eliminate the residue of lime
that prevents its proper operation.
Slowly remove and disconnect the filter holder be-
cause any remaining pressure could cause splashes
or squirts. Clean the clogged filter holes with a small
brush or a pin.
Try using coarser coffee blends.
amper coffee inside the filter using less pressure.
Fit the tank securely by pushing it as far as it will go.
Wash the silicone disc (E) under running water,
bending it slightly on the sides in order to free the
centre hole of any residue of coffee grounds that
could clog it (Fig. 12).
Check that the water level in the tank is correct. If
necessary, fill it with cool tap water
Replace the pod in the filter holder (K).
Remove the pod filter holder (K), clean the seat with
a sponge, and put a new pod inside.
A more finely ground blend must be used to obtain
a more concentrated and hotter coffee. Anyhow,
this problem is easily solved thanks to the Thermoc-
ream® System, which always guarantees hot coffee
accompanied by a reach cream, even with coarsely
ground beans.
11
Publicidad
Tabla de contenido
