Measuring Blood Pressure; Positioning The Cuff - Beurer BM 76 Manual De Instrucciones

6. The hour flashes on the LCD Display. Set the hour
with the +/- Buttons and press the SET Button to
confirm.
7. The minutes flash on the LCD Display. Set the
minutes with the +/- Buttons and press the SET
Button to confirm.
8. 'On' will flash in the LCD Display. Use the +/-
Buttons to select whether to activate ('On') or
deactivate ('Of') automatic Bluetooth
to a mobile device. Press the SET Button to confirm
and exit. Note that keeping Bluetooth
increase battery drain.

7. Measuring Blood Pressure

The blood pressure monitor needs to be at room
temperature when measuring. Measurements can
be performed on either arm.

Positioning the Cuff:

Place the cuff on to the bare left
upper arm. The circulation of
the arm must not be hindered
by tight clothing or similar.
The cuff must be placed on
the upper arm so that the
bottom edge is positioned
0.8 - 1.2 in (2-3 cm) above
the elbow and over the artery.
The line should point
to the centre of the palm.
Now tighten the free end of
data transfer
®
the cuff, but make sure that it
is not too tight around the
activated will
®
arm and close the
hook-and-loop fastener. The
cuff should be fastened so that
two fingers fit under the cuff.
Now insert the cuff line into
the connection for the cuff
connector.
Blood pressure can vary between the right and left
arm, which may mean that the measured blood
pressure values are different. Always perform the
measurement on the same arm.
17