Publicidad
EN
!
i
f The uniT is noT insTalled correcTly This can resulT in serious
injury or maTerial damage
(s
ee warnings and precauTions
s
ecure The base firmly To The concreTe floor using anchor
(
bolTs
noT included in The supply
Once the definitive location of the unit has been decided, pay
special attention to the work area that will be above the inductor;
this work area shall be free of objects and any electrical devices and
ensure that the floor is level. Once you have finished the above
steps, secure the unit to the floor. The lift base itself can be used as
a pattern to establish the correct fixing locations (fig. 2).
To extend the life of the unit and the pump, use a filter at the control
panel input.
Fig. 2
Balcrank® Corporation · Weaverville, NC 28787 Tel.: 800-747-5300 · Fax: 800-763-0840 · www.balcrank.com
Installation / Instalación
WARNING
. r
.
ead The warnings
).
).
1
For model 4450-002:
1. Fix the pump through eye bolt with bolt and nut (2) (fig.5)
2. Screw the connector (8) into air motor inlet and connect the tube
(9) (Fig. 4).
For model 4450-003:
1. Place pump support and screw in the bolts (1) (Fig.3)
2. Fix the pump (4) to follower plate (5) with grub screw (6) (Fig. 4)
3. Fix the pump on the mounting plate with three hex bolts (3) (Fig.
6).
4. Screw the connector (8) into air motor inlet and connect the tube
(9) (Fig. 7).
5. Connect the tube to non-return valve (10) (Fig. 4)
Fig. 3
R. 07/18
SB4228
3
Publicidad
