M And M Lo Manual Flash Operation - Leica CF 22 Instrucciones

measured with a pre-flash. The light reflected
from the pre-flash is evaluated by the camera.
According to the evaluation, the following flash
exposure is adjusted by the camera to the pho-
tographic situation (see Camera manual).
You don't have to worry about the flash set-
ting, the camera electronics automatically en-
sures the correct flash output.
For the range of the flash light, check the indi-
cation in the LC Display (2) of the flash unit
(see "Automatic flash range indication," p. 33).
When the shot is correctly illuminated, the text
o.k. appears for about 3 s on the LC Display of
the flash unit. (see "Exposure control indica-
tion", p. 33).
Note:
Make sure that the no secondary light sources
shine directly into the lens: This will confuse
the camera's measuring system!
Settings on flash unit
1. Switch on the flash unit.
2. Keep pressing the MODE button (3) until dis-
play flashes.
TTL
The setting is immediately effective and auto-
matically saved after 5 s.
and Lo manual flash operation
M M
In this operating mode, an unregulated flash at
full power P1/1 at
P 1/8 at Lo is emitted.
M
The system is adjusted to the photographic
situation by the selection of the aperture set-
ting on the camera or by setting the partial
lighting level. The distance from the flash unit
to the subject that must be maintained to en-
sure correct flash exposure is shown in the
flash unit's LC Display (see "Automatic flash
range indication", p. 33).
Settings on flash unit
1. Switch on flash unit.
2. Keep pressing the MODE button (3) until the
or Lo flash in the display.
M M
The setting is immediately effective and auto-
matically saved after 5 s.
32
or the partial light power
M