Erreka ROLLER V-II Manual Del Usuario página 19

By pressing ENTER again, the console analyses the memory inserted. If it
is not valid, the following will appear
INSERT MEMORY
ERROR NOT VALID
If the memory is compatible and contains no errors, the console will request
the installation no. to be recorded in the memory. The same number used
for personalising the transmitters must be entered.
By pressing ENTER again, the edited installation no. is validated to avoid
personalising the memory with a badly entered code by mistake.
INSTALL. NO. * * * *
VALIDATE ENT/ESC
If the code entered is incorrect, press ESC (Escape) to begin again. If it is
correct, press ENTER and the console will begin to initialise the memory.
If the code is correct, the console will display the edited installation no.
at the top of the screen and the no. of records contained in the memory,
250, 500 or 1000, to the right of the top line.
The bottom line will indicate that the memory is being encoded and to
the right the memory cell being encoded will be shown.
INST. * * * *
ENCODE MEMO
When it has finished, the following message will appear on the second
line:
MEMORY OK.
And Enter or Esc is pressed to exit. If Escape is pressed, the menu is directly
accessed.
If Enter is pressed, a process is entered that allows for the memory to be
filled automatically, requesting the number of the first and last four-figure
transmitter codes between 0000 and 9999, as well as the channel on which
the memory is to work. The console will fill the memory with the codes
from the first to the last, inclusive.
FIRST TRANSMITTER?
If this has been entered by mistake or if this function is not required, return
to the menu by pressing the Escape key.
In the event of wishing to fill the memory with previously personalised or
re-recorded codes, enter the code of the first transmitter with its four
figures and press Enter.
The code of the last transmitter to be recorded in the memory is then
requested.
LAST TRANSMITTER?
Enter the complete four-figure code and press Enter.
The console will display the codes entered and will request validation by
pressing Enter.
TRANSMITTER XXXX*YYYY
VALIDATE ENT/ESC
0250
XXXX
19
English