Waeco MSH-50 Instrucciones De Montaje Y De Servicio página 16

Caution! To check the voltage in electrical cables, use only a
diode test lamp (see B 1) or a voltmeter (see B 2). Test lamps
(see B3) which light up consume too much current and the
vehicle electronics may be damaged.
Caution! In order to avoid damages, please make sure that there
is sufficient free space for the drill outlet (see B4). Every drill hole
must be deburred and treated with a rust preventing agent.
Warning! Due to risk of short-circuiting, always disconnect the
negative pole of the battery prior to any works on the electrical
equipment of the vehicle. In case of vehicles with a
supplementary battery, also disconnect this negative pole.
Caution! When disconnecting the negative terminal of the
battery, all volatile memories of the convenience electronics lose
their stored data. Depending on the vehicle equipment, the
following data may need to be reprogrammed:
Radio code, vehicle clock, time switch clock, on-board computer,
seat position
Instructions on how to set these values can be found in the
relevant operating instructions.
Warning! The components of the device which are inside the
vehicle must be securely fixed so that they cannot come loose
and injure the vehicle's occupants under any circumstances
(sudden braking, traffic accident).
Sharp and heavy objects must not be placed on the seat as the seat
heating may be damaged otherwise. For persons with a disturbed
heatsensation, it is recommended to operate the magic heat only on
level I. If the seat heating is turned on, no heat insulating objects, such
as blankets or coats, must be placed on the seat. The seat heating may
be damaged by spilled liquids on the seat. Never turn on the seat
heating if the seat is wet
Safety and installation instructions
.
17