golmar 295 Serie Manual De Instalación página 13

DOOR PANEL INSTALLATION
Pass the wiring through the hole made in the bottom part
of the embedding box. Level and flush the embedding
box. Once the embedding box is placed, remove the
protective labels from the attaching door panel holes.
Insert the hinge in the embedding box lockers.
Press the hinge ends to insert them in the door panel
lockers as shown.
Open the terminal connector cover and connect
the wires as shown on the installation diagram.
In case of door panels with more than one module
link the main module with the push buttons modules
through the UC junctions and wire them as shown
on page 27.
P
lace the embedding box.
H
old the door panel on the embedding box.
D
oor panel wiring.
23 24
P
lace the nameplate labels.
F
inal adjustments.
If after starting the system it's considered that
the audio volume isn't correct, proceed
with the necessary adjustments as shown.
C
lose the door panel.
Fix the door panel to the embedding box
by using the supplied vandal resistant screws
and the special screwdriver.
DOOR PANEL INSTALLATION
Telephone
Door panel